Jus' Roach · 09-13-2005, 01:04 PM

Parameters: Roland VersaWorks on an SP-300v

I was having inconsistant results trying to cut an image after removing it and laminatiing. Sometimes it would find the crop marks, sometimes it would just sit and play with itself.
With the help of Corey & Barry (and some wasted vinyl) I found a simple, yet unknown to me solution....
RIP IT!
I was leaving the job in the queue
When you reload the material and change the settings to "Cut Only" then send the job, it asks if you want to RIP it again. Clicking YES solved my problem.

09-13-2005, 01:04 PM	#1
Jus' Roach Senior Member Join Date: Jun 2005 Location: Colorado Posts: 188 Printer: Roland VersaCamm SP-540v	trial & error seems to be the best teacher Parameters: Roland VersaWorks on an SP-300v I was having inconsistant results trying to cut an image after removing it and laminatiing. Sometimes it would find the crop marks, sometimes it would just sit and play with itself. With the help of Corey & Barry (and some wasted vinyl) I found a simple, yet unknown to me solution.... RIP IT! I was leaving the job in the queue When you reload the material and change the settings to "Cut Only" then send the job, it asks if you want to RIP it again. Clicking YES solved my problem.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)