GraphiXtreme · 08-25-2005, 04:34 PM

This was the first time I made a dimensional sign like this. Used Econollite for both parts. I bonded the 8th Note to the primary using polyurethane "Ultimate Glue" (similar to Gorilla Glue). Not sure if I'd use that stuff again since it expands so much. I knew that going into it, but thought I had left enough room for expansion, but I didn't and it came out in several places. I removed some of it after it had dried, but looked like crap. So, I took some black caulk and went around the perimeter to finish it off. Looked pretty good.

Barry · 08-25-2005, 05:11 PM

Awesome dude... Big quest is did you laminate it?

PGilleland · 08-25-2005, 05:19 PM

Very nice Chris

08-25-2005, 04:34 PM	#1
GraphiXtreme Cat Herder Join Date: Jun 2005 Location: Arlington, WA Posts: 608 Printer: Roland VersaCAMM SP-540V	4x8 Econolite This was the first time I made a dimensional sign like this. Used Econollite for both parts. I bonded the 8th Note to the primary using polyurethane "Ultimate Glue" (similar to Gorilla Glue). Not sure if I'd use that stuff again since it expands so much. I knew that going into it, but thought I had left enough room for expansion, but I didn't and it came out in several places. I removed some of it after it had dried, but looked like crap. So, I took some black caulk and went around the perimeter to finish it off. Looked pretty good. Attached Thumbnails __________________ Author of "GraphixCALC" sign pricing software. - - - - - - - - - - If you think you can or you think you can't, you're right! - - - - - - - - - - Roland SP-540V w/Triangle MLD Bulk Ink System / Wasatch SoftRip 6.4 / DingTec 60" Cold Laminator / SummaCut D60 / CorelDRAW X3 / Adobe Creative Suite CS2 / AlienSkin Eye Candy / PhotoZoom Pro / CoCut Pro 13 / EyeOne Proof - - - - - - - - - - For we wrestle not against flesh and blood...

08-25-2005, 05:11 PM	#2
Barry Administrator Join Date: Jun 2005 Location: Cypress, Texas Posts: 1,977 Printer: Versacamm SP300	Awesome dude... Big quest is did you laminate it? __________________ Mimaki JV3-130SPII - Triangle Mild Solvent inks (MLD) Graphtec FC7000 Cutter Wasatch SoftRip v6.0

08-25-2005, 05:19 PM	#3
PGilleland Senior Member Join Date: Jun 2005 Location: Rainbow TX Posts: 353 Printer: Mimaki JV3 160SP	Very nice Chris __________________ Paula http://www.signs67.com signs@signs67.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)