Philip Swanson · 08-17-2008, 11:38 AM

Can anyone tell me whare to find the Encoder Module on an SP300? I have the repair manual but there isn't anything listed for the ENCODER MODULE or ENCODER STRIP

tdgraphics · 08-17-2008, 05:03 PM

Lift the perspex flap and look above the rail that the head runs side to side on. There is a what looks like clear strip above the rail, this is the encoder strip. The encoder module is attached the rear of the head and runs up and down the encoder strip. This tells the head where is is as it traverses along the rail.

Neil

BDodson827 · 08-18-2008, 03:38 PM

Not trying to be a jerk, but one thread per topic will suffice, if you feel it has dropped too low to be noticed, always feel free to reply to your own thread to bump it back up.

Philip Swanson · 08-19-2008, 10:20 PM

Sorry that was a mistake I had to leave the room and when I came back I sent it again by mistake.

08-17-2008, 11:38 AM	#1
Philip Swanson Member Join Date: Jan 2006 Posts: 30 Printer: VERSA CAMM SP300	Encoder Module Can anyone tell me whare to find the Encoder Module on an SP300? I have the repair manual but there isn't anything listed for the ENCODER MODULE or ENCODER STRIP __________________ LGL

08-19-2008, 10:20 PM	#4
Philip Swanson Member Join Date: Jan 2006 Posts: 30 Printer: VERSA CAMM SP300	Oops Sorry that was a mistake I had to leave the room and when I came back I sent it again by mistake. __________________ LGL

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-17-2008, 05:03 PM	#2
tdgraphics Senior Member Join Date: Jan 2006 Location: Allenwood, Co. Kildare, Ireland Posts: 481 Printer: VersaCamm SP540 V,Graphtec Cutter, RS1400C	Lift the perspex flap and look above the rail that the head runs side to side on. There is a what looks like clear strip above the rail, this is the encoder strip. The encoder module is attached the rear of the head and runs up and down the encoder strip. This tells the head where is is as it traverses along the rail. Neil

08-18-2008, 03:38 PM	#3
BDodson827 Super Moderator Join Date: Apr 2006 Location: Dallas Posts: 780 Printer: 74" Roland - Dye Sub Convert	Not trying to be a jerk, but one thread per topic will suffice, if you feel it has dropped too low to be noticed, always feel free to reply to your own thread to bump it back up.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)