07-18-2008, 07:49 AM
Junior Member
Join Date: Oct 2006
Location: Bellmawr NJ
Posts: 27
Printer: Roland XC-540 Flexi SP 8
If you are going to go cheap buy this laminator (a little off topic I know)
NEW 63" Power Cold Roll Laminator mounting printing
I bought one from ebay for 1595 it works ok the only issues I have with it is the backing liner must be rolled up manually because the backing is to slippery to create enough friction to roll itself also when feeding rolled print set it on top of feed roller not on it this way it will create just enough friction to keep the print tight. The laminate will not tighten on the role clampies they use so I had to rig it up to hold the roll and create enough drag to hold the laminate tight. When I am tightening the rollers down there is a spot just before u get to tight that the roll tensionrs spin freely I tighten just to that point and then just a tweek this will then laminate perfectly until my alignment gets so far out I have to start over usually after 30 or 40 feet.
NEW 63" Power Cold Roll Laminator mounting printing
I bought one from ebay for 1595 it works ok the only issues I have with it is the backing liner must be rolled up manually because the backing is to slippery to create enough friction to roll itself also when feeding rolled print set it on top of feed roller not on it this way it will create just enough friction to keep the print tight. The laminate will not tighten on the role clampies they use so I had to rig it up to hold the roll and create enough drag to hold the laminate tight. When I am tightening the rollers down there is a spot just before u get to tight that the roll tensionrs spin freely I tighten just to that point and then just a tweek this will then laminate perfectly until my alignment gets so far out I have to start over usually after 30 or 40 feet.
