[Jus' Roach]

The problem stems from your job settings.

Here is what Paula found for me.....

Originally Posted by PGilleland

This happened to me the very first time I tried contour cutting. I found this response on rolanddga forum and have not had any problem since:

"Roland recommends:
Outer Frame Cutting of EPS File
It is necessary to setup the margin around the outer frame of the EPS file in order to cut the rectangular frame of the EPS file.
Contents
Margin for a EPS data has been able to set on the Roland VersaWorks version 1.3.0.0 and above.
[File Format] tab has been added in [Queue A(B) properties] window. You can set the margin in this tab.
The margin is recommended to set 0.35mm (=1pt) or more. When the numerical value less than 0.35mm (=1pt), the margin might not be added.

[File Format] tab is appeared in [Job Settings] window, however, you cannot change the margin in [Job Settigs] window. You can change the margin in [Queue A(B) properties] window.---------------------------------------
What I came up with:If this is the case … 0.35mm = .014”
When this is entered into the File Format area .014 converts to .01 = .25mm, which would be smaller then the recommended .35mm.
It may require the .02” or .50mm for it to work correctly."


I don't remember where I set mine and I'm not at the shop now to see.