jgolo · 11-24-2005, 03:50 PM

I get the feeling tht most of you on here do not use Versaworks, but I will ask anyway, just in case this happens with other software. I have a basic square image about 8"x10" with a contour cut around the outside and when I go to print& cut it may only cut 2 sides?? and maybe a little on an untouched corner. Even in the preview window in versaworks where you see the red dotted line for the contour cut - you only see the 2 sides that will cut. I have tried to move the image in versaworks (to the middle of the page) and get the same results. Not sure what I am doing wrong? I had this happen on an image that was 2" x .75" - but I here that is because the image was too small, at least that is what my dealer said.

Thanks- john

11-24-2005, 03:50 PM	#1
jgolo Senior Member Join Date: Sep 2005 Location: Colorado Posts: 383 Printer: SP-540V -Triangle - CX300- Titan 165	Versaworks not cutting all the way around I get the feeling tht most of you on here do not use Versaworks, but I will ask anyway, just in case this happens with other software. I have a basic square image about 8"x10" with a contour cut around the outside and when I go to print& cut it may only cut 2 sides?? and maybe a little on an untouched corner. Even in the preview window in versaworks where you see the red dotted line for the contour cut - you only see the 2 sides that will cut. I have tried to move the image in versaworks (to the middle of the page) and get the same results. Not sure what I am doing wrong? I had this happen on an image that was 2" x .75" - but I here that is because the image was too small, at least that is what my dealer said. Thanks- john