gtjet · 11-02-2006, 02:01 PM

Yes I had already upgraded to V6.3 firmware and during the install went to page 12 and changed the last number to 1, it was under system switch but I almost missed this step as it was under the upgrade firmware portion of the instructions I recieved, I just got lucky and saw it.

Actually the whole pump switch thing was not too bad but it definitely was not a cake walk either and I can see a lot of ways a guy could mess the install up.

It probably would be advisable to use a qualified Roland Tech. Thanks Mleg1972 for posting as that would not have been a good thing to miss.

11-02-2006, 02:01 PM	#5
gtjet Senior Member Join Date: Dec 2005 Location: Nebraska Near Wyoming Border Posts: 227 Printer: Roland VersaCamm SP 300	Yes I had already upgraded to V6.3 firmware and during the install went to page 12 and changed the last number to 1, it was under system switch but I almost missed this step as it was under the upgrade firmware portion of the instructions I recieved, I just got lucky and saw it. Actually the whole pump switch thing was not too bad but it definitely was not a cake walk either and I can see a lot of ways a guy could mess the install up. It probably would be advisable to use a qualified Roland Tech. Thanks Mleg1972 for posting as that would not have been a good thing to miss. __________________ Glenn & Pearl