[mleg1972]

Originally Posted by gtjet

Well it is installed (48 min 32 sec)
If anyone needs some help, I will try since I think I may be the first to do so
so far outside of a Roland Tech.

It was not easy but it was not terrible to do either. I would rate it about a 5 on a 10 point scale and for comparison would rate removing the old pump about a 2 (Gary really helped us on that though)

Anyway feel free to email at gpjohnson1@earthlink.net or pm
if you need too and I will try to help.

Besides the physical installatiion, you have to upgrade to the latest firmware version, and then enter service mode to set system switch 12 to a 1. Failure to do so can ruin the pump as the stepper motors need to run at a slower cycle so as not to ruin the new pump. If you haven't done so, pm me and I'll help you out.